wiring ceiling fan and light with one switch

The 14/3 Type, NM-B Romex cable, is stapled to the side of the attic trusses. 14/3 Romex cable for ceiling fan power is stapled to the attic truss Fiberglass wire fishing rod resting on top of attic insulationĪ fiberglass wire pulling rod was used to pull the 14/3 Romex cable across the attic. The green arrow indicates where the ceiling drywall meets the wall’s top plate. The blue arrow points to a hole that was drilled into the top plate of the wall so that a cable could be fished down to the switches. Drilled hole in wall top plate view from the attic. Click for my article about converting a switched outlet to hot for more details and photos about how I did this. I changed the wiring connections so that the outlet was live (Hot) at all times, and the switch box now had a LINE hot and a LINE neutral. The additional white and black wires connected to the LINE hot and LINE neutral feed power to another area of the house. One of the white wires connected to the outlet is the LINE neutral conductor, which is part of the same cable as the LINE black wire. The black wire from the switch box is connected to the outlet. The white wire should have been re-identified with a different color other than white, gray, or green. The white wire is the LINE hot at the switch, and the black wire is the LOAD.

One of the black wires is the LINE or hot wire into the outlet box, but instead of getting terminated directly onto the outlet, it is connected to the white wire that goes to the wall switch. In the above photo of an electrical outlet controlled by a wall switch, notice the white wire and two black wires connected together. Top Of Page An electrical outlet that is controlled by a wall switch However, the white wire should have been re-identified with a different color because it is not a neutral. When the wiring is checked at the outlet, a white wire is seen connected to the hot black wires. In the above switch box, the white wire is usually the hot wire or the LINE, and the black wire is the LOAD. CONTROL CEILING FAN AND LIGHT SEPARATELY The old existing wall switch that controlled the switched outlet Using my links helps to keep this website FREE.īelow is an example of a ceiling fan installation I did for a client where I converted the existing single wall switch that controlled an electrical receptacle outlet to two wall switches that now control the ceiling fan and light kit separately. As an Amazon Associate, I earn from qualifying purchases. NOTE: Some text links below go to applicable products on Amazon. Electrician: How do I control my ceiling fan and light separately with two wall switches?Īnswer: To control the ceiling fan and light separately with two wall switches, a three-conductor cable needs to be installed from the switch location to the ceiling fan location. With this arrangement, the fan and light are turned off and on with the wall switch and the fan speeds are controlled with the builtin pull-chain on the fixture.Dear Mr. The source ground is spliced through to the ceiling box and connected to the green ground wire on the fan and to any grounding terminal found there. The source neutral is spliced through to the white wire on the fan.

At the ceiling location, it's spliced to the black and blue wires from the fan and light. The black wire running to the ceiling box is connected to the other terminal on the switch. Here the hot source is connected directly to the switch and 2-wire cable runs from there to the ceiling fan. Use this wiring when the power source originates at the wall box and you want to control both the fan and light with a single switch. With this arrangement, power to the fan is controlled with a builtin pull-chain on the motor housing and the light is controlled with the wall switch. The red wire on the 3-wire cable is connected to the switch and at the fan, it's spliced with the blue wire to the light. The source hot wire is spliced to the black fan wire to hardwire it directly to the circuit and to a pigtail connecting the switch. The source neutral and ground are spliced through to the fan location. In this wiring, the source is at the switch and 3-wire cable runs from there to the fan and light. Wiring a Fan and Light to a Single Switch

Wiring ceiling fan and light with one switch